Electric Heteromorphosis Bender Safety Operating Procedures
Electric Heteromorphosis Bender Safety Practices 14:
1. The operator must be trained by the Electric Heteromorphosis Bender
safety operation procedure, familiar with the structure, performance, principle, routine maintenance and programming of the machine, and can be operated after passing the examination.
2, Electric Heteromorphosis Bender work, no one is allowed near the pipe bending range and set up a protective warning sign. Stabilize the tube to prevent it from being scratched by the crowbar. The operator can only stand on the outside.
3. Check around the work site to remove any debris that interferes with work and traffic. There must be no oil on the ground to avoid slipping. The stack of workpieces should be neat and tidy to prevent collapse and injury.
4. Adjust the position and required an angle of the parts.
5. Check that the protective device on the Electric Heteromorphosis Bender
is intact. If it is not installed, it is not allowed to drive. The intermediate frequency bender should have the good grounding and electrical insulation, and the voltage should be stable.
6. Start the oil pump, whether the system pressure is kept within the specified range. If it is high, it will damage the hydraulic components and waste power. If it is too low, it will affect the work.
7. Adjust the vertical lifting guide rail so that the guiding mold pressing cylinder advances to clamp the tight iron pipe.
8. Normal operation Put the workpiece into the bending mold, and the front end touches the positioning, and the footswitch is pressed to complete.
9. When the empty car is running, check whether the mechanical operation is normal and whether the electrical switch is sensitive and easy to use. After everything is ok, work again.
10. Before the operation, first check whether the lubrication points are short of oil, whether the moving mechanism is loose, whether the safety protection device is reliable, and can be operated after confirmation.
11. When two people work at the same time, they must cooperate closely and coordinate. A person should be assigned to operate the switch. It is not allowed to talk to other people during operation to prevent malfunction.
12. The operator must not leave the machine when the machine is started.
13. When bending, the idea should be concentrated. It is forbidden to put the hand or other items into the work area. In case of emergency, press the emergency stop button of Electric Heteromorphosis Bender
, then turn the twist switch to the manual position, manually reset, if Failure occurred and timely repair.
14. After the work is finished, cut off the power supply and do the cleaning and lubrication work.