Hot rolling fishtail forged machine installation and use method
Hot rolling fishtail forged machine picture:
1:Hot rolling fishtail forged machine
for the whole machine. Long-term mass production must be installed on a sturdy and level ground and reliably grounded. The function should be dry and ventilated.
2: Lubrication: The reducer and bearing should be greased. The machine can be used directly after adding grease. The reducer is recommended to be filled with No. 00 deceleration grease before use, and the bearings and the inner gear of the cover are made of calcium-based grease. The gears are used once every shift, the bearings are once every three months, and the number of lubrications should be adjusted according to the usage. The reducer is replaced for three months for the first time, and then the oil is cleaned once every year.
3: Install the selected mold on the main shaft of the press, prepare the boot, adjust the length to be pressed, heat the blank to be processed to 800-900 degrees Celsius, and start the main machine (note the direction of rotation) to input press molding.